The Superhuman ClubBy Muscleheadon

Journal · Supplements

How to read a protein tub

First published 5 February 2020 · revised November 2026

The front of a protein tub is an advertisement, and two seconds is about what it deserves. Then turn it round. Nearly everything worth knowing is on the back, in two places: the nutrition panel and the ingredient list.

The serving size is whatever the maker says it is

Every figure on the nutrition panel refers to one serving, and manufacturers set their own. So two tubs can show the same protein per serving while one of them gets there with a noticeably larger scoop. You are not comparing like with like.

The fix is usually printed right beside it. The panel generally carries a second column based on a fixed weight of powder. Compare protein in that column and the scoop size stops mattering.

The ingredient list is in order

Ingredients are listed by weight, largest first and smallest last. That one fact turns a block of small print into something you can read. For a protein powder, check which protein source leads, whey concentrate or whey isolate for example. Check whether a carbohydrate powder such as maltodextrin sits near the top. Then see which sweeteners, flavourings, thickeners and colours have been added.

A short list is not automatically better. It is easier to understand, which counts for something.

Amounts stated, or amounts hidden

Labels deal with added ingredients in one of two ways. A fully disclosed label states the amount of every ingredient individually, so you can see exactly how much of each is in a serving. A proprietary blend groups several ingredients under a single name and gives only the total weight of the group. The ingredients are named, in descending order, but their individual amounts are not. The blend may be mostly its first ingredient with only traces of the rest, and nothing on the label lets you find out.

Blends are common, and this is not a scandal. The point is narrower: a disclosed label can be checked and a blend cannot.

One thing about the protein figure

Protein content is normally measured through nitrogen. Free amino acids such as glycine contain nitrogen too, so adding them raises the measured protein figure without adding complete protein. If you see single amino acids in the ingredient list of something sold as protein, give the headline number a closer look.

While the tub is in your hand

  • Batch number, manufacturing date and expiry date.
  • The food regulator's licence number, and the name and address of the importer or manufacturer.
  • Allergen statements, such as milk or soy.
  • Any third-party testing mark, and whether the testing body is named.
  • An intact seal under the lid.

That is the whole habit. Find the serving size, read the ingredients in order, and prefer a label that states its amounts over one that hides them in a blend. It takes a minute. If the terms themselves are unfamiliar, concentrate, isolate and hydrolysate explains the common ones.

First published on the earlier Muscleheadon site and rewritten for The Superhuman Club in November 2026. It is general information, not medical advice.

All articles